Tankless Water Heaters- DIY Plumbing Tips to Get it at Home

So, when your much anticipated holidays are just around the corner, you must be looking for a refreshing week with your friends and family. And also some time to revitalize your drooping spirit. But, when you finally get into the shower, what you find is nothing but ice-cold water, because the hot water systems at your place are damaged. Well, the ideal solution, according to Plumber Toronto, to deal with this situation is simply investing in tank-less water heater, also known as instantaneous heaters.

What are Tankless Water Heaters?

Tankless water heaters are no different from a standard water storage tank heater and operate in the same way as the latter. The tankless system can usually heat up 50 gallons of water and keeps on continually heating the water to maintain a constant temperature. Once some quantity of hot water is used, the system gets refilled by itself. The tank uses high energy to maintain a constant temperature. No doubt, the automated system makes tankless heater highly effective.

Benefits of using Tankless Water Heaters

The good news is Tankless water heaters are easy to maintain and they are highly efficient. Not only does it save you maintenance cost, but also help you get the plumbing done at low cost. Infact, you can get the system upgraded at low cost.

DIY Plumbing Tips for Upgrading Tankless Water Heaters

You can easily cut down the plumbing cost by using these tips. Read on to know how to upgrade the system without hiring a plumber.

Prepare the Tank

Shut off the water flow in the cold side of the water heater. Now unfasten hot water faucet to alleviate some pressure in the lines.Now, turn off the power at the breaker. Once it’s done, drain out about a gallon of water to relieve complete pressure and it will help to lower the water level.

Relieve pressure from the pipes

With the help of a measuring tape, estimate the length of each section of 3/4″ copper (or any other metal if used) pipe.Cut it into pieces of equal length. Now assemble the pieces together with any fittings. Now screw the adaptors in proper place, so that the pieces can be fit together. Now place the assembled pipe and check if the measurement is fine.

Cut the water line cautiously

Once the pipe is done, the pre-fitted valve assembly should be aligned in the cold water. Dip it until it makes a proper 90-degree angle intersecting the water line. With a pipe cutter you can easily cut the pipe closest to the water line firs. Move it to the top of the pipe and cut down the excess part.

Assemble the Expansion Tank Connections

While cutting down the pipe, make sure that the length of the pipe coming off as the ‘T’ is extremely short to alleviate the strain on the connection.Clean and flux the joints appropriately, so that the pressure is available at the right spots. Now turn on the water heater to test for leaks.

If you find all of these too difficult or are too preoccupied with your work, you can always call upon the best professional plumbing contractor Plumber Toronto. They are always ready to help.